JTEKT-KOYO 6210-CM Deep Groove Ball Bearing - 50 mm ID, 90 mm OD, 20 mm Width GearWrench 5mm Jack Bush (Initial State-Hard-Grounded)

5mm Jack Bush (Initial State-Hard-Grounded) Fuse T10A Hot Air Yes Inert Gas Function The inlet pressure is set permanently to 200 kPa by a pressure regulator

Rated for operation up to 300 degrees F

One of the easiest and most effective ways to dismount small to medium size bearings is to use a mechanical puller

this knife features Microtech's signature out-the-front (OTF) deployment mechanism

Simple snap-in installation for easy assembly

JTEKT-KOYO 6210-CM Deep Groove Ball Bearing - 50 mm ID, 90 mm OD, 20 mm Width GearWrench 5mm Jack Bush (Initial State-Hard-Grounded)Deep Groove Ball Bearing JTEKT KOYO deep groove ball bearings are versatile, robust, and accommodate radial and axial loads in both directions. Their simple design, low friction, and high speed capability make them suitable for a wide range of industrial applications, from electric motors to gearboxes. Sealed and shielded variants protect against contamination, while open versions allow easy lubrication.